Pasos de instalación

1. 

   Paso 1

   Attach the handle to the applicator by placing the lower piece into the receiver and inserting the locking pin.
2. 

   Paso 2

   Then insert the top piece of the applicator into the lower piece, set the height, and install the locking pin.
3. 

   Paso 3

   Loosen the knob, and load a roll of film with the loose end extending UNDER the roll, adhesive side facing up. (See photo for orientation.) Tighten the knob.
4. 

   Paso 4

   Feed the film over the roller on the front of the applicator so the adhesive side is now facing down, toward the TPO membrane.
5. 

   Paso 5

   Center the seam film over the gap in the MembraneShield™ Dirt-Blocking Film and push the Seam Film Applicator forward to cover the exposed seam, ensuring the adhesive portion of the film is only applied to the exposed TPO surface.
6. 

   Paso 6

   When complete, cut the seam film with a knife to separate from Seam Film Applicator.