Drill-Tec™ Masonry Anchor
The Drill-Tec™ Masonry Anchor is designed to attach termination bars to concrete
or masonry walls. This fastener is available with either a long-lasting stainless
steel or zinc plated steel pin. There are two diameters available, 1/4” and 3/16”.
The lengths range from 7/8” to 2”.
Specifications
The fastener will be a Drill-Tec™ Masonry Anchor. The fastener must meet GSA
specification number FFS-325, Group V, Type 2, Class 3. The fastener must be made
in the U.S.
Application
Predrill a 1/4” or 3/16” hole using a carbide tip SDS or straight shank drill bit.
The diameter of the hole must match the diameter of the masonry anchor. The predrilled
hole must be a minimum of 1/2” deeper than fastener embedment. The Drill-Tec Masonry
Anchor is then installed with a hammer. Minimum fastener embedment into the substrate
should be 3/4” for a masonry anchor with a 1/4” diameter or 5/8” for a masonry anchor
with 3/16” diameter.
Physical Data
Shank Diameter: 3/16” or 1/4”
Shank Material: Zinc Coated Steel or Nylon
Pin Material: Zinc Coated Steel or Stainless Steel
Packaging:1000/Bulk Carton or 1000/Carton of ten individual 100 count boxes.
|
