Drill-Tec™ Extra Heavy Duty ASAP
(Assembled Screw And Plate)
The Drill-Tec™ Extra Heavy Duty ASAP® (Assembled Screw and Plate)
is a specialized, high performance fastener designed to secure insulation and single-ply
membrane to steel. The Drill-Tec Extra Heavy Duty ASAP is a Drill-Tec Extra Heavy
Duty #15 Fastener assembled with a Drill-Tec 2-3/8” Barbed Galvalume®
Plate.
Specifications
The fastener will be a Drill-Tec™ Extra Heavy Duty ASAP® with
a thread diameter of .275. The fastener must have 12 threads per inch and a drill
point. Also, the fastener must be heat treated per specification OMG-1. The Drill-Tec
Extra Heavy Duty #15 Fastener will be assembled with a 2-3/8” Galvalume®
Steel Barbed Plate.
Coating Requirement
The fastener will be coated with the Drill-Tec CR-10 corrosion resistant coating.
When subjected to 30 Kesternich cycles (DIN 50018), the fastener must show less
than 15% red rust and surpass Factory Mutual Approval Standard 4470.
Application
The Drill-Tec Extra Heavy Duty ASAP® must penetrate steel decks a
minimum of 3/4”. The Drill-Tec Extra Heavy Duty ASAP® should always
be tested on site by a GAF representative to determine performance and proper installation
procedure. Call GAF to schedule testing.
Note: Make sure not to overdrive the fastener. Fastener must be
tight enough so that the plate doesn’t turn. Factory Mutual requires that the fastener
penetrates the steel deck at the top flute.
Physical Data
Head Diameter: .435
Head Style: #3 Phillips Truss
Thread Diameter: .275
Packaging: 200, 250/carton
Plate Diameter: 2-3/8”
|
