|
|
Drill-Tec™ ASAP® 3SInsulation Fastener The Drill-Tec™ ASAP® 3S (Assembled Screw and Plate) is designed to secure insulation to steel and wood substrates. The Drill-Tec ASAP® 3S is Drill-Tec Standard #12 Roofing Fastener assembled with Drill-Tec 3” Galvalume® Plate.
The Drill-Tec ASAP® 3S is available in lengths from 2-1/4” to 8”
in stock. Longer lengths are assembled to order. The Drill-Tec ASAP®
3S is Factory Mutual and Dade County approved. Application
The Drill-Tec ASAP® 3S must penetrate steel decks a minimum of 3/4”.
Drive the fastener until the screw head is seated securely; with very rigid insulation
boards, watch for the plate to dimple. For the fastest, most effective method of
installation, use the TallBoy® or ShortBoy® tool. Specifications The fastener will be a Drill-Tec™ ASAP® 3S with a thread diameter of .220. The fastener must have 12.5 threads per inch and a 30° spade point. Also, the fastener must be heat treated per specification OMG-1. The Drill-Tec ASAP® 3S Fastener will be assembled with a Factory Mutual approved, Drill-Tec 3” Galvalume® Plate. The fastener must be Factory Mutual approved and made in the U.S. Coating Requirement
The fastener will be coated with the Drill-Tec CR-10 corrosion resistant coating.
When subjected to 30 Kesternich cycles (DIN 50018), the fastener must show less
than 15% red rust and surpass Factory Mutual Approval Standard 4470.
The Drill-Tec ASAP® must penetrate steel decks a minimum of 3/4”.
Using a screw-shooter, drive the fastener until the screw head is seated securely;
with very rigid insulation boards, watch for the plate to dimple. For For plywood
deck, the screw must penetrate the deck a min of 1/2”; for wood plank a 1” min embedment
is required.
Head Diameter: .435 |
Documents
|
