Product availability is subject to change without notice. Not all products are available from all facilities.
Master Flow's Galvanized Steel Flat Sheet is the ultimate product for custom fittings. This flat sheet is made of 30-gauge galvanized steel for durability and sturdiness. You can cut this sheet into almost any size for your job. Great for general needs other than HVAC as well.
Perforated Hanger Strap - Hang round pipe, rectangular duct or other plumbing pipes with the Master Flow Perforated Metal Hanger Straps and prevent the system from sagging over long runs. These durable galvanized-steel straps are easy to install with nails or screws.
Woven Vinyl Hanger Strap Woven Vinyl Hanger Straps are used to hang insulated flexible duct, round pipe or rectangular duct. This helps prevent the duct system from sagging over long runs.
Flexible Duct Connectors serve as a coupling between two sections of insulated flexible duct. Both ends of the connector have a bead to provide adequate holding power. Each end is also crimped to ensure an easy fit every time.
The Ceiling Collar has a slightly oversized opening to accommodate pipe. This collar is designed for use as a finishing piece to help hide surface imperfections where pipe passes through a ceiling, wall or floor. It is made of 30-gauge, galvanized steel to provide strength and durability.
Round Duct Caps are designed to terminate a round pipe run in a HVAC system. This cap is made with sturdy galvanized steel and is designed to install easily with sheet metal screws.
Rectangular Duct Caps are used to terminate a rectangular duct run in an HVAC application. This rectangular duct cap is made of 30-gauge, galvanized steel for strength and durability. It can be installed using appropriate sheet metal screws.
Master Flow Drive Cleats and "S" Cleats, are used to join sections of rectangular duct in HVAC systems. These cleats are sleeves of galvanized steel that help to securely assemble the top and bottom ("S") and left and right sides (Drive) of rectangular duct runs.
Dampers balance and adjust the air flow in individual runs of round pipe in HVAC systems. Our dampers include hardware that make it easy to install into existing round pipe as well as new.
The Bathroom Fan Eave Vent is used to vent bathroom exhaust outside through the undereaves. Features include easy installation and a white louver to match most undereaves.
Fiberglass Weave fabric is slightly tacky to make for an easier installation. This duct repair fabric provides closure for duct-board boxes and helps patch leaks and holes. To help ensure an airtight seal, it can be used with mastic as code dictates.
Master Flow’s Duct Mastic is a water-based adhesive that creates an air-tight seal on duct seams and joints by eliminating air leakage. Sealant increases the overall efficiency of the duct system, which can cut energy costs. Available in tubes or tubs.
Use this R6.0 - 60 sq. ft. Fiberglass Duct Wrap Insulation to reduce condensation, absorb noise and improve the air temperature efficiency of your duct system.
Wrap your new or existing ductwork with this Master Flow Ductwork Sleeves and enjoy consistent air temperature and reduced system condensation and noise.